Dodge Journey: Switch, oil pressure
Description
The engine oil pressure switch is located on the right side of the engine block. The switch screws into the engine main oil gallery. The normally closed switch provides an input through a single wire to the low pressure indicator light on the instrument cluster.
Removal
1. Raise vehicle on hoist.
2. Remove heat shield that covers oil pressure switch.
3. Disconnect oil pressure switch electrical connector.
4. Position an oil collecting container under switch location.
5. Remove switch by unscrewing from the engine block.
Installation
1. Apply Mopar Thread Sealant to the switch threads.
2. Install oil pressure switch.
3. Connect electrical connector.
4. Install oil pressure switch heat shield.
5. Lower vehicle.
6. Start engine and check for leaks.
7. Check engine oil level and adjust as necessary.
Pump, engine oil
Removal
Fig. 275: Oil Pump & Pick-up Tube
- BOLTS
- O-RING
- PICK-UP TUBE
- BOLT
- OIL PUMP
NOTE: The oil pump pressure relief valve can be serviced by removing
the oil pan ...
Valve, oil pressure relief
Removal
Fig. 285: Oil Pressure Relief Valve
- RELIEF VALVE
- SPRING
- RETAINER CAP
1. Remove the oil pan.
2. Remove the pressure relief valve (1) by remove the threaded retaining cap ...
See also:
Reinforcement, bumper, rear
REMOVAL
Fig. 25: Rear Bumper Reinforcement
1. Remove rear fascia. See Removal .
2. Support bumper reinforcement (1) on a suitable lifting device.
3. Mark position of bolts (2) on frame rail ...
TO OPEN AND CLOSE THE HOOD
Two latches must be released to open the hood.
1. Pull the hood release lever located under the left side
of the instrument panel.
Hood Release
2. Outside of the vehicle, locate the safety latch ...
Indicators
Indicators are located in various positions within the CCN and are all
connected to the CCN electronic circuit
board. All indicators, except the inverter indicator (if equipped), are
controlled b ...
