Dodge Journey: TOWING A DISABLED VEHICLE
Without The Ignition Key
Front Wheel Drive (FWD)
Special care must be taken when the vehicle is towed with the ignition in the LOCK position. Flatbed towing is the preferred towing method. However, if a flatbed towing vehicle is not available, a wheel lift towing vehicle may be used. Furthermore, rear towing is not recommended with the front wheels on the ground, as transaxle damage can result. If rear towing is the only alternative, a front end dolly must be used. Proper towing equipment is necessary to prevent damage to the vehicle.
All Wheel Drive (AWD)
The manufacturer requires towing your vehicle with all four wheels OFF the ground using a flatbed.
CAUTION:
Towing this vehicle using any other method could
result in extensive damage to the transfer case and/or
transmission. Such damage is not covered by the
New Vehicle Limited Warranty.
Towing This Vehicle Behind Another Vehicle (Flat Towing With The Key In The Ignition And All Four Wheels On The Ground)
CAUTION:
• If the vehicle being towed requires steering, the
ignition switch must be in the ON position, not in
the LOCK or ACC position.
• Do not attempt to tow this vehicle from the front with sling-type towing equipment. Damage to the front fascia will result.
• Do not push or tow this vehicle with another vehicle as damage to the bumper fascia and transaxle may result.
If you must use the accessories (wipers, defrosters, etc.) while being towed, the key must be in the ON position, not the ACC position. Make certain the transaxle remains in NEUTRAL.
Front Wheel Drive (FWD)
Your vehicle may be towed under the following conditions: • The shift lever must be in NEUTRAL.
• The distance to be traveled must not exceed 15 miles (25 km).
• The towing speed must not exceed 25 mph (40 km/h).
CAUTION:
Exceeding these towing limits may cause a transaxle
failure. Such damage is not covered by the New
Vehicle Limited Warranty. If the transaxle is not
operative, or if the vehicle is to be towed more than
15 miles (25 km), the vehicle must be transported
either with a flatbed truck or with the front wheels
off the ground.
All Wheel Drive (AWD)
Your vehicle may be towed under the following conditions: • The shift lever must be in NEUTRAL.
• The distance to be traveled must not exceed 15 miles (25 km).
• The towing speed must not exceed 25 mph (40 km/h), and both front and rear wheels must be on the ground.
CAUTION:
Exceeding these towing limits may cause a transaxle
failure. Such damage is not covered by the New
Vehicle Limited Warranty. If the transaxle is not
operative, or if the vehicle is to be towed more than
15 miles (25 km), the vehicle must be transported on
a flatbed truck.
Towing This Vehicle Behind Another Vehicle With A Tow Dolly
Front Wheel Drive (FWD)
Rear towing is not recommended with the front wheels on the ground, as transaxle damage can result. If rear towing is the only alternative, a front end dolly must be used. Proper towing equipment is necessary to prevent damage to the vehicle.
All Wheel Drive (AWD)
The manufacturer requires towing your vehicle with all four wheels OFF the ground using a flatbed.
CAUTION:
Towing this vehicle using any other method could
result in extensive damage to the transfer case and/or
transmission. Such damage is not covered by the
New Vehicle Limited Warranty.
FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand, or snow, it can often be moved by a rocking motion. Turn your steering wheel right and left to clear the area around the front wheels. Then shift back an ...See also:
Removal
BULB
Each rear lamp unit for this vehicle consists of two pieces. An outer rear
lamp unit that is secured at the rear of
each quarter panel includes bulbs for the park (or tail) lamps, the brake ( ...
Removal, Installation
REMOVAL
Fig. 54: Removing /Installing Propeller Shaft
CAUTION: Propeller shaft removal is a two-man operation. Never
allow propeller shaft
to hang from the center bearing, or while o ...
Description
Four-wheel disc brakes are standard on this vehicle. Each disc brake assembly
consists of the following major
components:
Caliper
Caliper adapter bracket
Pads (Shoe and lining assemblies)
...