Operation

The standard front and available rear heating-A/C systems used in this vehicle are blend-air type systems. In a blend-air system, a blend-air door controls the amount of conditioned air that is a ...

A/C Performance

The A/C system is designed to provide the passenger compartment with low temperature and low humidity air. The A/C evaporator, located in the HVAC housing is cooled to temperatures near the fre ...

See also:

Housing, coolant outlet
Removal Fig. 78: COOLANT OUTLET CONNECTOR - 2.7L - BOLT (2) - BOLT (2) - COOLANT OUTLET CONNECTOR WARNING: Do not remove pressure cap with the system hot and under pressure ...

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

Intermediate shaft, gas
REMOVAL 2.4L 1. Remove the right half shaft. Fig. 44: Intermediate Shaft - 2.4L 2. Remove the three intermediate shaft bolts (1). 3. Remove the intermediate shaft (2). 2.7L 1. Remove the r ...