Installation

2.4L Fig. 52: 2.4L Knock Sensor CAUTION: Always torque knock sensors to the correct torque specification. Over or under tightening effects knock sensor performance. Ensure the electr ...

Removal

2.4L Fig. 59: Identifying Ignition Coil Electrical Connectors NOTE: Prior to removing coil, spray compressed air around coil top to make sure no dirt drops into the spark plug tube. 1. ...

See also:

Module, heated seat
DESCRIPTION Fig. 4: Locating Heated Seat Module The heated seat module (2) is located under the driver front seat. It has a single electrical connector (1) and a push pin style retainer that se ...

Crossmember, front suspension
REMOVAL 1. Raise and support the vehicle. Fig. 33: Tire And Wheel Mounting 2. On each side of the vehicle, remove the wheel mounting nuts (3), then the front tire and wheel assembly (1). Fi ...

DRIVING ON SLIPPERY SURFACES
Acceleration Rapid acceleration on snow covered, wet, or other slippery surfaces may cause the front wheels to pull erratically to the right or left. This phenomenon occurs when there is a differe ...