Installation

Fig. 28: Sealing Boot Installation on Interconnecting Shaft - SEALING BOOT - RAISED BEAD IN THIS AREA OF SEALING BOOT - GROOVE - INTERCONNECTING SHAFT 1. Slide new sealing boot clamp (2 ...

Description, Diagnosis and Testing

DESCRIPTION The inner joints of both half shaft assemblies are tripod joints. The outer joints of both assemblies are Rzeppa Joints. The tripod joints are true constant velocity (CV) joint assembl ...

See also:

With intermediate shaft
NOTE: Never grasp the halfshaft assembly by the inner or outer boots. This can cause damage to the boot, which will allow contaminants to enter the C/V joint. NOTE: The inner tripod joints ...

ROOF LUGGAGE RACK — IF EQUIPPED
The roof rack cross rails and side rails are designed to carry cargo weight. The load must not exceed 150 lbs (68 kg), and it should be distributed uniformly over the cross rails. In addition, the ...

Switch, backup lamp
REMOVAL Fig. 249: Back-Up Lamp Switch 1. Disconnect battery negative cable. 2. Raise vehicle on hoist. 3. Disconnect backup lamp switch connector. 4. Remove backup lamp switch (1). INSTA ...