Installation

WITH FOOT LEVER 1. Pass most of the front parking brake cable down through the access hole in the floor pan from inside the vehicle. Fig. 195: CABLE HOUSING RETAINED IN LEVER 2. Insert the lev ...

Removal

1. Release the parking brake. 2. Manually release the parking brake cable tension. 3. Raise and support the vehicle. Fig. 206: TIRE AND WHEEL MOUNTING 4. Remove wheel mounting nuts (3), t ...

See also:

Installation
LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Chain and sprockets, timing
Removal TIMING CHAIN AND CAM SPROCKETS Fig. 334: TIMING MARK ALIGNMENT - CAMSHAFT TIMING MARKS - CRANKSHAFT TIMING MARKS 1. Disconnect negative battery cable. 2. Drain cooling system. ...

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fat ...