Dodge Journey: Lens, instrument cluster

REMOVAL

Instrument Cluster
Fig. 8: Instrument Cluster Lens Locking Tabs

1. Remove instrument cluster from vehicle. See Removal .

2. Separate the lens from the cluster by gently prying on the locking clips (1) around the perimeter of the lens.

3. Separate lens from instrument cluster and remove.

INSTALLATION

Instrument Cluster
Fig. 9: Instrument Cluster Lens Locking Tabs

1. Align lens locking tabs (1) with instrument cluster mask assembly and snap securely into place.

2. Install the instrument cluster into vehicle.

3. Connect battery negative cable.

    Diagnosis and Testing, Removal, Installation
    DIAGNOSIS AND TESTING INSTRUMENT CLUSTER As a quick diagnosis, the cluster will perform a functional check of the odometer display, transmission range display and warning indicators after the ign ...

    Pod, switch
    DESCRIPTION Fig. 10: Accessory Switch Bank Module The Accessory Switch Bank Module (ASBM) is located in the center stack area of the instrument panel just below the heater and air conditioner d ...

    See also:

    Diagnosis and Testing
    STRUT ASSEMBLY Fig. 80: Strut Assembly (Exploded) Inspect the strut assembly for the following conditions: Inspect for a damaged or broken coil spring (7). Inspect for a torn or damaged dust ...

    Description, Standard procedure
    DESCRIPTION Fig. 331: Identifying Timing Drive System Components The timing drive system has been designed to provide quiet performance and reliability to support a NON freewheeling engine. The ...

    Removal
    LEFT-HAND-DRIVE CAUTION: The vacuum in the power brake booster must be pumped down before removing the master cylinder to prevent the booster from sucking in any contamination. This ...

    0.3481