Dodge Journey: Radio

STANDARD PROCEDURE

RADIO BACKUP

The radio hard disk drive (HDD) can be backed up to save customer data in the event that a radio replacement is required. This procedure can only be done with all radios with a hard disk drive. All other radios do not have a HDD.

1. Turn the ignition to RUN, engine OFF.

2. Power on the external HDD.

3. Connect the external HDD to the radio using the USB (Universal Serial Bus) cable. The radio display will change to the "Manage My Files" screen.

4. Connect the scan tool and preform the following steps to place the radio into "Dealership Mode":

  • ECU View
  • Radio
  • Misc. Functions
  • Service Mode
  • Start
  • Next

5. Follow the on screen instructions on the radio to back up the radio HDD.

REMOVAL

RADIO/RADIO HEAD Refer to the RADIO/RADIO HEAD for removal procedures
REMOTE RADIO DISPLAY Refer to the REMOTE RADIO DISPLAY for removal procedures

NOTE: REQ radios only must be put into "Transportation Mode" before removal. With Ignition in RUN or ACCESSORY, press SET and DISC simultaneously until the radio displays "TRANSPORTATION" on the display or for 5 seconds.

RADIO/RADIO HEAD

1. Disconnect and isolate the battery negative cable.

2. Remove the instrument panel center bezel.

3. Remove the radio mounting fasteners.

4. Carefully pull the radio out as necessary and disconnect the electrical connectors and antenna cables.

5. Remove the radio from the vehicle.

REMOTE RADIO DISPLAY

1. Disconnect and isolate the battery negative cable.

2. Remove the instrument panel center bezel.

3. Remove the radio display mounting fasteners.

4. Carefully pull the radio display out as necessary and disconnect the electrical connectors and antenna cables.

5. Remove the radio display from the vehicle.

INSTALLATION

RADIO/RADIO HEAD Refer to the RADIO/RADIO HEAD installation procedures.
REMOTE RADIO DISPLAY Refer to the REMOTE RADIO DISPLAY installation procedures.

RADIO/RADIO HEAD

1. Connect the electrical connectors and antenna cables.

2. Firmly seat the radio into position and install the mounting fasteners.

3. Install the instrument panel center bezel.

4. Connect the battery negative cable.

REMOTE RADIO DISPLAY

1. Connect the electrical connectors.

2. Seat the display into position and install the mounting fasteners.

3. Install the instrument panel center bezel.

4. Connect the battery negative cable.

NOTE: REQ RADIO , After installation of the radio, remove the radio from "Transportation Mode" by pulling the IOD fuse or using the scan tool and perform a battery reset.

    Monitor, media system
    REMOVAL Fig. 14: Removing / Installing Mounting Fasteners 1. Disconnect and isolate the battery negative cable. 2. Open the video screen to access the mounting fasteners. 3. Remove the mount ...

    Speaker
    OPERATION Two wires connected to each speaker, one feed circuit (+) and one return circuit (-), allow the audio output signal electrical current to flow through the voice coil. The wiring informa ...

    See also:

    Removal
    WARNING: Review safety precautions and warnings in this part before performing this procedure. See Heating and Air Conditioning/Plumbing - Warning and. Failure to follow the warnin ...

    MEDIA CENTER 830N (REU) — AM/FM STEREO RADIO AND 6–DISC CD/DVD/HDD/NAV CHANGER — IF EQUIPPED
    NOTE: The sales code is located on the lower right side of the unit’s faceplate. The REU Multimedia system contains a radio, Sirius Satellite Radio player, navigation system, six disc CD/ DVD pl ...

    Without intermediate shaft
    NOTE: Never grasp the halfshaft assembly by the inner or outer boots doing so may damage to the boot. NOTE: The inner tripod joints are designed with a retention feature that prevents t ...


    0.0089