Dodge Journey: POWER STEERING

The standard power steering system will give you good vehicle response and increased ease of maneuverability in tight spaces. The system will provide mechanical steering capability if power assist is lost.

If for some reason the power assist is interrupted, it will still be possible to steer your vehicle. Under these conditions, you will observe a substantial increase in steering effort, especially at very low vehicle speeds and during parking maneuvers.

NOTE:
• Increased noise levels at the end of the steering wheel travel are considered normal and do not indicate that there is a problem with the power steering system.

• Upon initial start-up in cold weather, the power steering pump may make noise for a short amount of time.

This is due to the cold, thick fluid in the steering system. This noise should be considered normal, and it does not in any way damage the steering system.

WARNING:
Continued operation with reduced power steering assist could pose a safety risk to yourself and others.

Service should be obtained as soon as possible.

CAUTION:
Prolonged operation of the steering system at the end of the steering wheel travel will increase the steering fluid temperature and it should be avoided when possible. Damage to the power steering pump may occur.

Power Steering Fluid Check

Checking the power steering fluid level at a defined service interval is not required. The fluid should only be checked if a leak is suspected, abnormal noises are apparent, and/or the system is not functioning as anticipated.

Coordinate inspection efforts through an authorized dealer.

CAUTION:
Do not use chemical flushes in your power steering system as the chemicals can damage your power steering components. Such damage is not covered by the New Vehicle Limited Warranty.

WARNING:
Fluid level should be checked on a level surface and with the engine off to prevent injury from moving parts and to ensure accurate fluid level reading. Do not overfill. Use only manufacturer’s recommended power steering fluid.

If necessary, add fluid to restore to the proper indicated level. With a clean cloth, wipe any spilled fluid from all surfaces. Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for the correct fluid type.

    DRIVING THROUGH WATER
    Driving through water more than a few inches/ centimeters deep will require extra caution to ensure safety and prevent damage to your vehicle. Flowing/Rising Water WARNING: Do not drive on, or cr ...

    PARKING BRAKE
    Before leaving the vehicle, make sure that the parking brake is fully applied. Also, be certain to leave the transmission in PARK. The foot operated parking brake is located below the lower left c ...

    See also:

    Switch, defogger, rear
    DESCRIPTION Fig. 5: EBL Switch (MTC) NOTE: Manual tri-zone temperature A/C-heater control shown in illustration. Other A/Cheater controls similar. The momentary push-button swi ...

    Input shaft, transmission
    DISASSEMBLY Fig. 175: Snap Ring At Input Shaft 1. Remove the snap ring (2) that retains the input shaft bearing and sixth gear to the shaft. Fig. 176: Press Bearing From Input Shaft 2. Using ...

    A WORD ABOUT YOUR KEYS
    Your vehicle uses a keyless ignition system. This system consists of a Key Fob with Remote Keyless Entry (RKE) transmitter and a Wireless Ignition Node (WIN) with integral ignition switch. You can ...

    0.0117