Cable, shift

REMOVAL Fig. 306: Identifying Knee Blocker 1. Remove the knee blocker (2). Fig. 307: Identifying Shift Cable At Shifter NOTE: Ensure the lock tab on the shift cable (2) is depressed before ...

Description, Operation

DESCRIPTION Fig. 313: Identifying Differential Assembly - DIFFERENTIAL CASE - RING GEAR - TRANSFER SHAFT - PINION GEAR - PINION SHAFT - SIDE GEAR The 41TE differential is a convent ...

See also:

Actuator, mode door, front
DESCRIPTION Fig. 12: Blend Door Actuators The mode door actuator (1) for the heating-A/C system is a reversible, 12-volt Direct Current (DC) servo motor, which is mechanically connected to the ...

ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms engine coolant and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. ...

BULB REPLACEMENT
Low Beam Headlamp, High Beam Headlamp, Front Turn Signal/Park Lamp, Side Marker Lamp 1. Open the hood. NOTE: It may be necessary to remove the air cleaner filter housing and position the Totally I ...