Dodge Journey: Removal, Installation

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions may result in possible serious or fatal injury.

NOTE: The HVAC housing assembly must be removed from vehicle and disassembled for service of the A/C evaporator.

Heating & Air Conditioning
Fig. 239: Evaporator Removal/Installation

NOTE: LHD model shown. RHD model similar.

1. Remove the HVAC housing and place it on a workbench.

2. Disassemble the HVAC housing to gain access to the A/C evaporator.

NOTE: If the foam insulator around the A/C evaporator is deformed or damaged, the insulator must be replaced.

3. Carefully lift the A/C evaporator (1) and the foam insulator (2) out of the lower half of the HVAC housing (3).

INSTALLATION

CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.

NOTE: When replacing multiple A/C system components, refer to the REFRIGERANT OIL CAPACITIES to determine how much oil should be added to the refrigerant system.

NOTE: If only the A/C evaporator is being replaced, add 10 milliliters (0.3 fluid ounce) of refrigerant oil to the refrigerant system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.

NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is disconnected. Failure to replace the rubber O-ring seals and metal gaskets could result in a refrigerant system leak.

NOTE: LHD model shown. RHD model similar.

Heating & Air Conditioning
Fig. 240: Evaporator Removal/Installation

NOTE: Make sure that the foam insulator is properly positioned around the A/C evaporator and in the HVAC housing.

1. Carefully install the A/C evaporator (1) and foam insulator (2) into the lower half of the HVAC housing (3).

2. Assemble the HVAC housing.

3. Install the HVAC housing.

4. If the A/C evaporator is being replaced, add 10 milliliters (0.3 fluid ounce) of refrigerant oil to the refrigerant system. When replacing multiple A/C system components, refer to the REFRIGERANT OIL CAPACITIES to determine how much oil should be added to the refrigerant system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.

    Description, Operation
    DESCRIPTION Fig. 238: Evaporator Description NOTE: LHD model shown. RHD model similar. The A/C evaporator (1) for the heating-A/C system is mounted in the HVAC housing, which is located be ...

    Line, A/C discharge
    DESCRIPTION Fig. 241: Discharge Line Description NOTE: 2.7L shown. Other engines similar. The A/C discharge line (2) is the refrigerant line that carries refrigerant from the A/C compresso ...

    See also:

    Lines, A/C underbody, extension
    Description Fig. 310: Underbody A/C Extension Lines Description Models equipped with the rear heating-A/C system use metal lines attached to the vehicle underbody to carry refrigerant and engin ...

    Installation
    LEFT-HAND-DRIVE Fig. 140: PEDAL AND BOOSTER MOUNTING - LHD 1. Carefully install the brake pedal and bracket assembly (1) in the vehicle lining up the bracket with the power brake booster mounti ...

    Assembly
    Fig. 239: Output Shaft #2 & Needle Bearing 1. Install the reverse needle bearing (1) onto the output shaft # 2 (2). Fig. 240: Synchronizer NOTE: Pay attention to the direction when inser ...

    0.009