Duct, floor distribution, rear

REMOVAL Fig. 159: Rear Floor Distribution Duct 1. Remove right quarter trim panel. 2. Remove the push-pin retainer (2) that secures the rear floor distribution duct (1) to the right inner qu ...

Description

Fig. 161: Rear Heater AC Housing Description Models with the rear heating-A/C system use a rear heater-A/C housing (1) that combines A/C and heating capabilities into a single unit mounted withi ...

See also:

Installation
LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Diagnosis and Testing
SUSPENSION AND STEERING CONDITION POSSIBLE CAUSES CORRECTION Front End Whine On Turns 1. Defective Wheel Bearing2. Incorrect Wheel Alignment 3. Worn Tires ...

Installation
2.4L FRONT Fig. 38: Removing/Installing Camshaft Position Sensor CAUTION: Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do n ...