Dodge Journey: Cleaning, Inspection
CLEANING
Drain cooling system and refill with clean water. Refer to drain and fill procedures in this service information .
Run engine with radiator cap installed until upper radiator hose is hot. Stop engine and drain water from system.
If water is dirty; fill, run, and drain system again, until water runs clear. Refill cooling system with a 50/50 mixture of the recommended ethylene-glycol and distilled water.
INSPECTION
After performing a cleaning/flush procedure, inspect all hoses, clamps and connections for deterioration and leaks. Inspect radiator and heater core for leaks.
SPECIFICATIONS
FILL VOLUMES
TORQUE
SPECIAL TOOLS
Fig. 8: BELT TENSION GAUGE ADAPTER - 8371
Fig. 9: HOSE CLAMP PLIERS 8495
Fig. 10: HOSE CLAMP PLIERS 6094
Fig. 11: FILLING AID FUNNEL 8195
Fig. 12: COOLING SYSTEM TESTER 7700
Fig. 13: COOLANT REFRACTOMETER 8286
Fig. 14: RELEASE TOOL 8875A
Standard procedure
DRAINING
When servicing the cooling system, it is essential that coolant does not drip
onto the accessory drive belts
and/or pulleys. Shield the belts with shop towels before working on the coolin ...
Accessory drive
...
See also:
Communication
DESCRIPTION
The primary on-board communication network between microprocessor-based
electronic control modules in
this vehicle is the Controller Area Network (CAN) data bus system. A data bus
ne ...
Fascia, front lower, closeout
REMOVAL
Fig. 11: Lower Fascia
1. Remove fasteners (5) to lower closeout.
Fig. 12: Push Pins - Front Lower Fascia
2. Remove push pins (1) to lower closeout.
3. Remove the front lower fascia.
...
Standard procedure
MODULE/PROGRAMMING ORDER REPLACEMENT GUIDE
MODULE PROGRAMMING
The Wireless Ignition Node (WIN) controls the Vehicle Theft Security System (VTSS),
Remote Keyless Entry
(RKE). When a Powertrain ...
