Dodge Journey: Seal, output flange

REMOVAL

Differential and Driveline
Fig. 93: Axle Seal Removal

  1. - SEAL
  2. - SCREWDRIVER

1. Raise vehicle on hoist.

2. Remove rear driveline module.

3. Use suitable screwdriver (2) to remove output seal (1).

INSTALLATION

Differential and Driveline
Fig. 94: Axle Seal Installation

  1. - HANDLE C-4171
  2. - INSTALLER 8493

1. Install output flange seal to differential housing using handle C- 4171A (1) and installer 8493 (2).

2. Install rear driveline module.

3. Check differential assembly fluid level and adjust as required.

    Seal, input flange
    REMOVAL Fig. 80: Removing /Installing Propeller Shaft NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance i ...

    Electronically controlled clutch
    REMOVAL NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues. Fig. 95: Removing /Installing Propell ...

    See also:

    Description
    Fig. 1: Front Suspension Components This vehicle has a gas pressurized MacPherson strut type front suspension design. Each side of the front suspension consists of these major components: ...

    Driving clutches
    DESCRIPTION Fig. 350: Identifying Input Clutch Assembly - INPUT SHAFT - UNDERDRIVE CLUTCH - OVERDRIVE CLUTCH - REVERSE CLUTCH - OVERDRIVE SHAFT - UNDERDRIVE SHAFT Three hydraulical ...

    Description, Diagnosis and Testing
    DESCRIPTION The inner joints of both half shaft assemblies are tripod joints. The outer joints of both assemblies are Rzeppa Joints. The tripod joints are true constant velocity (CV) joint assembl ...

    0.0241