Connector, data link

DESCRIPTION Fig. 1: Data Link Connector The Data Link Connector (DLC) (2) is a 16-way molded plastic connector insulator on a dedicated take out of the instrument panel wire harness. This conne ...

Description, Operation

DESCRIPTION Fig. 2: Antilock Brake Module - ANTILOCK BRAKE MODULE (ABM) - HYDRAULIC CONTROL UNIT (HCU) - PUMP/MOTOR The Antilock Brake Module (ABM) is a microprocessor-based device which ...

See also:

Pulley, idler
Removal 2.4L ENGINE Fig. 30: ACCESSORY DRIVE BELT IDLER PULLEY - 2.4L - UPPER PULLEY - LOWER PULLEY 1. Remove accessory drive belt. 2. Remove upper idler pulley (1) and bolt. 3. Re ...

Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...

Removal
CLUTCH - FIXED DISPLACEMENT A/C COMPRESSOR WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnin ...