Cable, shift

REMOVAL Fig. 306: Identifying Knee Blocker 1. Remove the knee blocker (2). Fig. 307: Identifying Shift Cable At Shifter NOTE: Ensure the lock tab on the shift cable (2) is depressed before ...

Description, Operation

DESCRIPTION Fig. 313: Identifying Differential Assembly - DIFFERENTIAL CASE - RING GEAR - TRANSFER SHAFT - PINION GEAR - PINION SHAFT - SIDE GEAR The 41TE differential is a convent ...

See also:

Disassembly
Fig. 28: Identifying Solenoid/Pressure Switch Assembly & Gasket - SOLENOID/PRESSURE SWITCH ASSEMBLY - GASKET NOTE: If transaxle is being overhauled (clutch and/or seal replacement ...

Assembly
Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

Installation
Fig. 25: Ball Joint Installation 1. Install Installer (2), Special Tool 9964-1, and Installer (4), Special Tool 9964-2 on Remover/Installer (5), Special Tool 8441-1. Place a new ball joint (stem ...